CNC lathes require oil change and maintenance, which many people have doubts about. Let's answer it for you below! The fully automatic CNC lathe is the same as your car. After buying it, you must pay attention to the hygiene of the countertop, so that dust and iron filings cannot enter the track. The harm that will be caused in the future is that the accuracy will become worse and the hand feel will become heavier. It is very heavy and laborious, so the new automatic CNC lathe should change the oil once a month in the early stage, once every three months in the next year, and three times in the first three months. When the oil of the fully automatic CNC lathe is changed, the impurities in the CNC lathe track will also be reduced. It will flow into the oil tank along the new oil, and will not stay in the track and will not scratch the track. The daily maintenance of the automatic CNC lathe is as follows:
1. Check the lubricating oil level to ensure the lubrication of the machine tool.
2. Check whether the coolant in the coolant tank is sufficient, and it cannot be increased in time.
3. Check the oil level of the pneumatic triplet, which is about 2/3 of the height of the entire oil pipe. The water vapor in the pneumatic triple oil filter tank is discharged from the drain switch every day.
4. Check the air pressure, loosen the adjustment knob, and adjust the pressure according to the principle of right-handed pressure increase and left-handed decompression, generally set to 5~7KG/CM2. The pressure switch is generally set to 5KG/CM2. When the pressure is lower than 5KG/CM2, the alarm will appear, and the system will display a [LOWAIRPRESSURE" alarm. After the pressure rises, the alarm message will disappear.
5. Check whether the air blowing in the inner taper hole of the CNC lathe spindle is normal, wipe the inner taper hole of the spindle with a clean cotton cloth, and spray light oil.
